This CANBUS gauge replaces the factory clock in your R33 Skyline with a fully configurable gauge to take advantage of the CANBUS data stream from your aftermarket ECU. It is made in the USA with the case 3D-printed in temperature-resistant ASA plastic, the buttons 3D-printed in ABS-like resin and purpose-designed electronics.
Features :
- Customizable appearances
- Configurable warning levels
- Quick gauge changes via buttons in factory locations
- Configuration via IOS or Android App over Bluetooth
- Auto-dimming display with night mode
- Single DTM 4 pin connector wiring
- Direct replacement of factory unit
Supported ECUs :
- Haltech (CAN protocol v2)
- Link (G-Series)
- Emtron (KV Series)
- AEM Infinity
- MoTeC M1 Series (GPR/GPA/Powertune Australia FW)
- ECUMaster Black Series
Requires a DTM-4 cable for installation
See install instructions for details
Supported gauges
(Requires that your ECU has the appropriate sensors and CAN configuration) :
- Battery Voltage
- Water Temp
- Oil Temp
- Fuel Temp
- Intake Air Temp
- Exhaust Gas Temp
- Water Pressure
- Oil Pressure
- Fuel Pressure
- Boost Pressure
- Air Fuel Ratio
- Ethanol Content
- Injector Duty
- Throttle Position
- Tire Temp/Pressure
- Fuel Tuning (AFR, Fuel Pressure, Injector Duty)
- Engine Health (Oil Temp/Presure, Water Temp/Pressure, IAT, Voltage, EGT)
- Boost Control (Boost vs. Target, Solenoid Duty, Ethanol %)
- Gear Position
- Speedometer
- 5 x Custom Digital Display with 1-7 user-configurable parameters
JDM to US License plate adapter bracket
A simple solution for mounting US plates on a JDM car. Don't drill holes in your license plate or your bumper! This simple plate bolts into the JDM plate frame and allows you to attach your US plate. It even comes with some nice stainless hardware and fancy washers!
Contact Us
Please fill out the form below and we’ll get back to you within 24 hours.
