


The NISMO R3 Turbocharger Assembly (14411-RSR47) is a ball-bearing turbocharger developed for RB26DETT engines. Compared with the NISMO R1 turbo, its revised compressor specification improves boost response and low- to mid-range torque, balancing street drivability with circuit performance and durability.
Sold individually: one turbocharger assembly. Two assemblies are required per vehicle for the RB26DETT twin-turbo configuration. This is not a complete twin-turbo kit.
Specifications
- NISMO part number: 14411-RSR47
- Compressor A/R: 0.60
- Compressor housing: T04B
- Compressor wheel: C106, 55 trim
- Turbine A/R: 0.64
- Turbine housing: T25
- Turbine wheel: GT25, 62 trim
- Bearing type: ball bearing
- Reinforced actuator with adjustable-length rod
- NISMO branding
Performance Reference
NISMO describes the R3 as suitable for RB26DETT engine builds up to 450 PS at 7,600 rpm and 50 kgf·m at 4,800 rpm when combined with appropriate camshaft and ECM tuning, according to NISMO measurement standards. These figures describe a tuned engine combination, not guaranteed output from turbocharger installation alone.
NISMO separately lists a calculated design capacity of 250 PS per turbocharger (250 PS × 2). Actual output depends on engine condition, supporting components and calibration; this figure is not a guaranteed horsepower rating.
Fitment and Installation
NISMO lists compatibility with RB26DETT-equipped vehicles. Confirm the engine configuration and installation requirements before ordering. Autech-branded vehicles are excluded from NISMO's listed fitment unless specifically noted.
Boost-control and engine ECU recalibration are required when installing this turbocharger. Professional installation and tuning are recommended.
Additional Parts
NISMO identifies the following parts for separate purchase as needed. Quantities shown are for the vehicle installation, not included contents of this assembly:
- Water and oil inlet pipe: Nissan 14499-AA400 × 2
- Front oil return pipe: Nissan 15197-06U00 × 1
- Gasket kit: Nissan 14401-24U26 × 1
- Stud bolt: Nissan 14064-05U01 × 8
- Stud bolt: Nissan 14414-17F00 × 10
Competition Part Notice
NISMO classifies this turbocharger as a competition part and states that it is excluded from NISMO warranty coverage. Competition parts prioritize motorsport performance and may require specialist installation and fine-tuning. Follow the supplied installation instructions and the applicable Nissan service manual.
The NISMO R3 Turbocharger Assembly (14411-RSR47) is a ball-bearing turbocharger developed for RB26DETT engines. Compared with the NISMO R1 turbo, its revised compressor specification improves boost response and low- to mid-range torque, balancing street drivability with circuit performance and durability.
Sold individually: one turbocharger assembly. Two assemblies are required per vehicle for the RB26DETT twin-turbo configuration. This is not a complete twin-turbo kit.
Specifications
- NISMO part number: 14411-RSR47
- Compressor A/R: 0.60
- Compressor housing: T04B
- Compressor wheel: C106, 55 trim
- Turbine A/R: 0.64
- Turbine housing: T25
- Turbine wheel: GT25, 62 trim
- Bearing type: ball bearing
- Reinforced actuator with adjustable-length rod
- NISMO branding
Performance Reference
NISMO describes the R3 as suitable for RB26DETT engine builds up to 450 PS at 7,600 rpm and 50 kgf·m at 4,800 rpm when combined with appropriate camshaft and ECM tuning, according to NISMO measurement standards. These figures describe a tuned engine combination, not guaranteed output from turbocharger installation alone.
NISMO separately lists a calculated design capacity of 250 PS per turbocharger (250 PS × 2). Actual output depends on engine condition, supporting components and calibration; this figure is not a guaranteed horsepower rating.
Fitment and Installation
NISMO lists compatibility with RB26DETT-equipped vehicles. Confirm the engine configuration and installation requirements before ordering. Autech-branded vehicles are excluded from NISMO's listed fitment unless specifically noted.
Boost-control and engine ECU recalibration are required when installing this turbocharger. Professional installation and tuning are recommended.
Additional Parts
NISMO identifies the following parts for separate purchase as needed. Quantities shown are for the vehicle installation, not included contents of this assembly:
- Water and oil inlet pipe: Nissan 14499-AA400 × 2
- Front oil return pipe: Nissan 15197-06U00 × 1
- Gasket kit: Nissan 14401-24U26 × 1
- Stud bolt: Nissan 14064-05U01 × 8
- Stud bolt: Nissan 14414-17F00 × 10
Competition Part Notice
NISMO classifies this turbocharger as a competition part and states that it is excluded from NISMO warranty coverage. Competition parts prioritize motorsport performance and may require specialist installation and fine-tuning. Follow the supplied installation instructions and the applicable Nissan service manual.
A Halloween special
The night is counting down
Frequently Asked Questions
Find answers to common questions about our products and services
Once your order ships, you'll receive a confirmation email with your tracking number and a link to track your shipment in real time. You can also track your order anytime by visiting the Order Status page using the link in your confirmation email. If you haven't received tracking info within 2–3 business days of your order, please contact us at Nizmopartsplug@gmail.com and we'll look into it right away.
We accept returns within 30 days of delivery on unused, uninstalled items in original packaging. A 20% restocking fee applies to eligible returns. Certain items are non-returnable, including electronic parts, special orders, and installed parts. Defective or incorrect items must be reported within 7 days. For full details, please review our Return Policy page before purchasing.
Yes — all parts sold on NizmoPartsPlug are brand new unless explicitly stated otherwise in the product listing. We source genuine OEM Nissan components and authentic aftermarket parts directly from trusted suppliers. If a part is used, refurbished, or a core charge item, it will be clearly noted in the product title and description.
Absolutely — if you don't see the part you need listed on our site, reach out to us at Nizmopartsplug@gmail.com or call us at (908) 265-4568 with the part number and we'll do our best to source it for you. We specialize in OEM Nissan and JDM components and have access to an extensive supplier network. Please note that special order parts may require a deposit and are non-returnable once ordered.
A core charge is a refundable deposit included in the price of select parts. It ensures that your old/used unit (the "core") is returned to us for remanufacturing or recycling. Once we receive your core in acceptable condition, the core charge is fully refunded. The exact core charge amount varies by item and will be listed in the product description. For questions about the core charge on a specific product, please contact us before purchasing and we'll be happy to clarify the amount, condition requirements, and refund process.
Customer Reviews
See what people are saying