Browse mechanical upgrades and service components for Nissan Z33 350Z and Fairlady Z builds, from suspension and steering to brake service and manual-transmission work. This selection includes OEM parts, HKS coilovers, SPL tie-rod ends, K-Fab steering components, and supporting NISMO cooler and hose listings.

Suspension & Steering

The HKS Hipermax III coilover listing specifies 2003–2007 350Z applications. SPL front outer tie-rod ends are sold as a pair. Match suspension parts to your body configuration, production period, ride height, installed components, and intended use. Confirm the rear eccentric-adjuster set against the actual adjustment position and hardware dimensions. Professional installation and alignment are recommended after suspension changes.

The K-Fab steering-rack listing is for left-hand-drive applications and explicitly excludes HR engines because of line-to-starter interference. It also identifies incompatibility with vehicles requiring the speed-sensitive steering module. Do not treat its broad year range as universal compatibility or bypass required equipment to make it fit. The K-Fab rack and solid rack-bushing listings are marked off-road use only.

Brake Service & Supporting Fluids

The front brake-pad set is for factory Brembo-equipped 350Z applications, not the base-model brake system. The NISMO brake-hose set and power-steering cooler have separate fitment and installation requirements. Confirm calipers, fittings, routing, and clearances against the installed equipment.

Nissan DOT 3 and DOT 4 fluid listings are separate choices, not a recommendation to mix or substitute specifications. Use the specification required by your vehicle and installed components. Apply brake-hardware grease only where the applicable service instructions permit; keep it off friction surfaces. Match power-steering fluid to the required system specification and check fluid-order shipping restrictions before purchase.

Manual Transmission & Clutch Service

The Nissan manual-transmission assembly listing is local pickup only in New Jersey or Florida. Confirm availability, pickup arrangements, transmission identification, and clutch-release compatibility before ordering. It is not a complete manual-swap package.

The third-gear assembly specifies 2003–2005 FS6R31A manual transmissions. The clutch operation-cylinder listing specifies early-style transmissions. Match the forged clutch-fork kit, control-lever spring, and shifter-retainer plate bolt to the actual installed gearbox rather than assuming every Z33 six-speed uses the same release components.

The flywheel-bolt listing is sold individually. Confirm engine and flywheel application, required quantity, and the correct installation procedure using the applicable service information. The NISMO clutch hose is a separate component, not a complete hydraulic system.

Differential & Axle Details

The NISMO differential oil cooler is a separate kit listing. The five-bolt rear axle-hardware kit must match the actual axle and differential flange arrangement, especially on converted cars. Verify the listed quantities and any additional components needed for the job.

Review individual listings for condition, package contents, current availability, special-order terms, and installation restrictions. Supplier listings do not establish stock physically held by NizmoPartsPlug. Provide build date, market, steering side, coupe or roadster configuration, engine, gearbox, brake equipment, and modifications when requesting fitment help.